Assembly and cable management for an L-shaped standing desk

Short answer: plan on two people and a clear floor the size of the whole L. Level the desk once it's upright. Then run cables with one loop of slack that's long enough for full height. Read your manual's duty-cycle rule before you test the lift over and over.

Checklist from the manuals

StepWhat the manuals say
PeopleVari: 2 people required; two people flip the desk upright.
Legs in syncVIVO: make sure all three legs are the same height before tightening the sync rods.
Testing the liftVari: stop after 2 minutes of continuous movement and resume after 20. Eureka: 2 minutes on, 18 off. VIVO: after a HOT alarm, wait 18 minutes.
First resetVari: a reset fully retracts the base below any set lower limit, so keep clearance under the desk.

Cable slack for a moving desk

The longest cable run is from the desk to the floor at full height. Measure your desk's top height (on its card), add a margin, and leave that much slack in one loop. Bundle cables to the frame so the loop rises with the desk. With the PC on the floor, this matters most; the gaming page has a PC-on-desk vs floor decision tree. If the desk shakes once loaded, work through the wobble fixes. Each desk's motor rest time is on its card, and the motor types are explained in single, dual or triple motor. Check the height calculator for your standing height, so you know how far the desk will actually travel.

FAQ

How many people does it take to assemble an L-shaped standing desk?
Plan on two. Vari's instruction booklet says two people are required for assembly and to flip the desk upright.
How do I manage cables on a standing desk with the PC on the floor?
Run every cable from the desk to the floor through one loop of slack that's long enough for the desk at full height, and tie the bundle to the frame so it moves with the desk rather than snagging.

Specs verified: November 2026 · Updated 2026-11-17 · How we research